02-17-2009, 10:48 PM | #21 |
Is this thing on?
Join Date: Feb 2009
Location: Ashe Co, NC (Near Boone)
Moto: '01, 929RR
Posts: 398
|
|
02-18-2009, 12:21 AM | #22 |
Chaotic Neutral
Join Date: Feb 2008
Location: Cherry Hill NJ
Moto: GV1200 Madura, Hawk gt
Posts: 13,992
|
any cut to the harness is going to make the bike's electricals more prone to failure. could and most likely would be a very minute percentage more likely. i put everything together and it wasnt worth it to me. besides, im getting pretty good at judging gear by speed/rpm
__________________
TWF Post whore #6 |
02-18-2009, 12:27 AM | #23 |
Is this thing on?
Join Date: Feb 2009
Location: Ashe Co, NC (Near Boone)
Moto: '01, 929RR
Posts: 398
|
That is very true, I won't deny that. If done properly, (I haven't seen the Acumen directions or harness yet so I can only assume) there shouldn't be any problems now or later. I don't plan on having to actually cut any wires, simply solder to some bare wire. I may not even get one, but it sure would be nice to have.
__________________
Dirty Harry said there's nothing wrong with a little shooting, as long as the right people get shot. |
02-18-2009, 12:29 AM | #24 |
Chaotic Neutral
Join Date: Feb 2008
Location: Cherry Hill NJ
Moto: GV1200 Madura, Hawk gt
Posts: 13,992
|
the other reason i was looking at them is that i was considering sending my gauge cluster away for an LED swap. but since that guy says he cant do the combo i wanted (all white w red needle) it would make no sense to tear the nose of the bike apart for a single mod
__________________
TWF Post whore #6 |
Bookmarks |
|
|