Tools

defector · 11-18-2010, 08:43 AM

Check out the companion line from Sears. I have a kit I keep in the truck that I have used on several occasions. IIrc, it was cheaper than the Craftsman stuff, and comes in a kit setup as well. I have never seen them advertised, but I have seen them at Sears several times.

As far as the heavy duty (professional) stuff, you simply can't get better than the Snap On, Mac, or Matco stuff. They are more expensive, but when you use them all day, everyday, you can't have tools breaking on a regular basis. Add the fact that the tool man comes to you weekly, and will recalibrate your torque wrenches for free, and replace "worn out" tools, the cost doesn't seem that much higher.
Yes, I am a tool snob.

11-18-2010, 08:43 AM	#35
defector My balls, your chin Join Date: Nov 2008 Location: The desert of Az Moto: 929, SV650, YZ250 Posts: 1,917	Check out the companion line from Sears. I have a kit I keep in the truck that I have used on several occasions. IIrc, it was cheaper than the Craftsman stuff, and comes in a kit setup as well. I have never seen them advertised, but I have seen them at Sears several times. As far as the heavy duty (professional) stuff, you simply can't get better than the Snap On, Mac, or Matco stuff. They are more expensive, but when you use them all day, everyday, you can't have tools breaking on a regular basis. Add the fact that the tool man comes to you weekly, and will recalibrate your torque wrenches for free, and replace "worn out" tools, the cost doesn't seem that much higher. Yes, I am a tool snob. __________________ Reading this signature may give you special powers, including the ability to run through walls. You should try it immediately.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode