So You Made an AR Lower on a CNC Machine?

LeeNetworX · 07-03-2013, 12:46 PM

That's adorable.

This guy made a custom intake manifold setup. You can also see the custom machined accessory drive. This is going on a small block Ford in the Factory Five coupe he's making.

Rangerscott · 07-03-2013, 02:34 PM

Eh. The bmx helmet was cooler.

goof2 · 07-04-2013, 12:19 AM

That looks badass, he should make a clear plexiglass hood scoop to show it off. The only issue I see is with all the mating surfaces I hope they don't leak.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

07-03-2013, 02:34 PM	#2
Rangerscott Viff6N Mutated Warrior Join Date: Mar 2009 Location: Texas Moto: '01 Honda VFR 800 & '09 ER-6N Posts: 8,704	Eh. The bmx helmet was cooler.

07-04-2013, 12:19 AM	#3
goof2 AMA Supersport Join Date: Feb 2009 Posts: 4,756	That looks badass, he should make a clear plexiglass hood scoop to show it off. The only issue I see is with all the mating surfaces I hope they don't leak.