Go Back   Two Wheel Fix > In the Garage or Shop > Aftermarket Modding

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 01-20-2010, 11:40 PM   #1
Digifox
Cl4p-Trap
 
Digifox's Avatar
 
Join Date: Nov 2008
Location: Columbus, Ohio
Moto: Your mom.
Posts: 734
Default Making a new exhaust

Well i'm not happy with the way my exhaust LOOKS..i love the can and the way it sounds...
But after i swap out the rear end of my EX250 for a 94+ EX500 (170/60-17)
I want to do a little "bolt on" fab work.

By modding my Full Yoshimura exhaust in to a "under" or side seat exhaust

Like this guy did on his 500
http://bikepics.com/pictures/916186/

Only i want to make mine like a mid pipe in being it slips into place with out any modification to the can or header.

Also i will use softer bent tubing. that will be supported by the "old" mount for the yoshi can
and again where the Passenger pegs went(where the can will mount with a special bracket)

And seeing that the ex500 rearsets and frame form more of a "one-piece" the "mid-pipe" will fallow the body lines.

I have a rough sketch sitting in front of me right now i will finish up a few more sketches and scan it.

And whats the longer exhaust going to do to my performance and tune?
__________________
Firm as cherries.
Digifox is offline   Reply With Quote
 

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 06:10 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.