Go Back   Two Wheel Fix > General > Off Topic

Reply
 
Thread Tools Display Modes
Old 02-17-2010, 09:10 PM   #11
G-Rex
Where to next?
 
G-Rex's Avatar
 
Join Date: Nov 2008
Location: OK to the C
Moto: TL1000R, Hayabusa, R1150RT
Posts: 1,333
Default

What kind of engineer are you that can't fix a simple motor?! Blasphemy I say! LOL

I'm thinking there may be grounds for turning your man card in too.
__________________
G-Rex is offline   Reply With Quote
Old 02-18-2010, 08:36 AM   #12
CasterTroy
................
 
CasterTroy's Avatar
 
Join Date: Nov 2008
Location: NC
Posts: 3,028
Default

Quote:
Originally Posted by G-Rex View Post
What kind of engineer are you that can't fix a simple motor?! Blasphemy I say! LOL

I'm thinking there may be grounds for turning your man card in too.
I'm not THAT kind of engineer I failed EE 200...TWICE

I think I need a job at NC Department of Administration.....so I can review drawings, totally miss entire detail sheets, yet find errors on canned details used since 95 ....then put a disclaimer that I need a sit-down with the engineer because the project is so complex that I need my hand held to actually further review them, even after 5 sheets of comments.

No kidding....I got a review set back yesterday Trace that had comments so stupid on it that I went from saying "Refer to detail 9/P4.8" to "OMG" and I actually faxed that back to Raleigh this morning I can't wait for the reponse
__________________
“Being tolerant does not mean that I share another one’s belief. But it does mean that I acknowledge another one’s right to believe, and obey, his own conscience.”
Viktor Frankl
CasterTroy is offline   Reply With Quote
Old 02-18-2010, 09:00 AM   #13
G-Rex
Where to next?
 
G-Rex's Avatar
 
Join Date: Nov 2008
Location: OK to the C
Moto: TL1000R, Hayabusa, R1150RT
Posts: 1,333
Default

Quote:
Originally Posted by CasterTroy View Post
No kidding....I got a review set back yesterday Trace that had comments so stupid on it that I went from saying "Refer to detail 9/P4.8" to "OMG" and I actually faxed that back to Raleigh this morning I can't wait for the reponse
Holycrap Troy! You gotta tell me what they say about that?! I've seen some pretty ridiculous review comments myself. The most ambiguous one I got was on a plan sheet and in huge red letters across the sheet it said *REALLY?*. I took an equally large red pen and wrote under it *REALLY!*. Didn't get any more stupid review comments after that.
__________________
G-Rex is offline   Reply With Quote
Old 02-18-2010, 09:14 AM   #14
Apoc
For Science. You Monster.
 
Apoc's Avatar
 
Join Date: Nov 2008
Location: Canada
Moto: '08 HD FLSTSB
Posts: 3,546
Default

Quote:
Originally Posted by G-Rex View Post
What kind of engineer are you that can't fix a simple motor?! Blasphemy I say! LOL

I'm thinking there may be grounds for turning your man card in too.
Funny you say that, most engineers I know are great in theory, but couldnt figure out which way to turn a wrench if their life depended on it.
__________________
Android OS causes gay. Dont let your child use Android (unless she's a hot female).

And dont let your babies grow up to be cowboys, either.
Apoc is offline   Reply With Quote
Old 02-18-2010, 09:33 AM   #15
CasterTroy
................
 
CasterTroy's Avatar
 
Join Date: Nov 2008
Location: NC
Posts: 3,028
Default

Quote:
Originally Posted by Apoc View Post
Funny you say that, most engineers I know are great in theory, but couldnt figure out which way to turn a wrench if their life depended on it.
Very true!

I stepped out years ago and built a show truck from a pile of rust...prior to that I hadn't done much further than change the oil in my vehicles. Then I got the TLR and went hog-wild. I can fix just about anything if I can find a manual...but I'm very hesitant to mess with electrical devices. Home electrical is also something I'm not fond of doing...but in 2001 I added a master suite to my old house and completely wired it (short of final panel connections) but most of my fellow engineers can swing a club like a pro...but couldn't change their own flat tire with AAA standing next to them giving blow by blow instructions
__________________
“Being tolerant does not mean that I share another one’s belief. But it does mean that I acknowledge another one’s right to believe, and obey, his own conscience.”
Viktor Frankl
CasterTroy is offline   Reply With Quote
Old 02-18-2010, 10:31 AM   #16
Particle Man
Custom User Title
 
Particle Man's Avatar
 
Join Date: Nov 2008
Location: Central NY
Moto: 2003 SV650S
Posts: 14,959
Default

I've got a vertical tank version (slightly larger?) and had to replace the brushes before.

I think I'll jump off the fucking roof before I do that again. I'm convinced they did not build these suckers to be rebuildable (I invented words when I ran out of normal curse words).



As much as I love this thing, it dies again I'll replace the brushes one more time and any time after that it's probably going and I'll put money into something like this:
Attached Images
File Type: jpg compressor.jpg (16.8 KB, 41 views)
__________________
I'm not "fat."
I'm "Enlarged to show texture."


Handle every stressful situation like a DOG: If you can't eat it or hump it, pi$$ on it & walk away.
Particle Man is offline   Reply With Quote
Old 02-18-2010, 10:34 AM   #17
CasterTroy
................
 
CasterTroy's Avatar
 
Join Date: Nov 2008
Location: NC
Posts: 3,028
Default

How did it act before you replaced them? I mean...what made you think that was it?
__________________
“Being tolerant does not mean that I share another one’s belief. But it does mean that I acknowledge another one’s right to believe, and obey, his own conscience.”
Viktor Frankl
CasterTroy is offline   Reply With Quote
Old 02-18-2010, 12:58 PM   #18
Krabill
WERA Yellow Plate
 
Krabill's Avatar
 
Join Date: Nov 2008
Location: Tulsa, OK
Moto: 08 WR250R, 12 XTZ1200
Posts: 558
Default

Don't you know anything about electrical devices? They all run on magic smoke. If the magic smoke escapes, they won't run anymore. Sounds like yours sprung a leak. It's broke
Krabill is offline   Reply With Quote
Old 02-18-2010, 01:06 PM   #19
Particle Man
Custom User Title
 
Particle Man's Avatar
 
Join Date: Nov 2008
Location: Central NY
Moto: 2003 SV650S
Posts: 14,959
Default

Quote:
Originally Posted by CasterTroy View Post
How did it act before you replaced them? I mean...what made you think that was it?
it just took longer and longer to kick on until finally it wouldn't kick on at all.
__________________
I'm not "fat."
I'm "Enlarged to show texture."


Handle every stressful situation like a DOG: If you can't eat it or hump it, pi$$ on it & walk away.
Particle Man is offline   Reply With Quote
Old 02-24-2010, 09:20 AM   #20
karl_1052
sergeant hatred
 
karl_1052's Avatar
 
Join Date: Jul 2009
Location: Ottawa
Moto: The bus
Posts: 2,723
Default

http://www.wikihow.com/Build-a-Simple-Electric-Motor
http://www.wikihow.com/Rewind-an-Electric-Motor
__________________
My wife was afraid of the dark...then she saw me naked and now she's afraid of the light.
karl_1052 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 05:10 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.